The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Chip then configure

An Elektor Distance Learning Course
Post a reply

Chip then configure

Postby iamborg1of1 » Sat Feb 02, 2019 10:37 am

Hi when i click on chip then configure instead of getting PICmicro Confiuration (simple)-slot2 I get a box with configure as title and under it Enter any required_CONFIG data with a blank box under it to put something in can any body tell me whats wrong and how to put it right This is with flowcode 4
Regards
Peter
iamborg1of1
 
Posts: 9
Joined: Thu Jan 02, 2014 10:49 am
Top
Post a reply

Return to Programming Embedded PIC Microcontrollers using Assembly, C and Flowcode

Who is online

Users browsing this forum: No registered users and 0 guests

Powered by phpBB® Forum Software © phpBB Group