The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Elektor Profiler: Using grbl to control the Profiler?

The electronics enthusiast's product design cycle
Post a reply

Postby tingo » Sat May 05, 2012 12:00 am

Hello,
Has anybody tried to use grbl (http://dank.bengler.no/-/page/show/5470_grbl) to control their Profiler?
An Arduino board as controller, and hey presto - instant G-code compatibility.
tingo
 
Posts: 5
Joined: Thu Jan 02, 2014 10:40 am
Top
Post a reply

Return to CAD, Simulation, PCBs, Making, 3D Printing

Who is online

Users browsing this forum: No registered users and 1 guest

Powered by phpBB® Forum Software © phpBB Group