The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Reflow Oven: reflow to use

The electronics enthusiast's product design cycle
Post a reply

Postby voclane » Wed May 30, 2007 12:00 am

Hello!

advised to me? according to you this reflow goes well? the heater are to infrared

http://i2.tinypic.com/4ly6ycp.jpg
voclane
 
Posts: 9
Joined: Thu Jan 02, 2014 10:39 am
Top
Post a reply

Return to CAD, Simulation, PCBs, Making, 3D Printing

Who is online

Users browsing this forum: No registered users and 2 guests

Powered by phpBB® Forum Software © phpBB Group