Can anyone here give advise concerning the type of solder paste which can be used for the Elektor SMT oven? Where to buy it and how to apply it?
regards,
Hugo
The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.
which paste
3 posts
• Page 1 of 1
by phonoplug1 » Thu May 06, 2010 12:00 am
To be honest, the oven doesn't really influence what paste you should use. You can apply it with either a syringe if its a simple and/or not very fine pitch, or ideally using a paste stencil.
As for the type, then there are many factors. Lead free or leadded depending on your requirements. The finer the paste (in terms of solder ball size), the more it costs, but the better its suited to fine pitch components.
As for the type, then there are many factors. Lead free or leadded depending on your requirements. The finer the paste (in terms of solder ball size), the more it costs, but the better its suited to fine pitch components.
- phonoplug1
- Posts: 44
- Joined: Thu Jan 02, 2014 10:37 am
3 posts
• Page 1 of 1
Return to CAD, Simulation, PCBs, Making, 3D Printing
Who is online
Users browsing this forum: No registered users and 1 guest