Following the HCS301 datasheet, I managed to decode the serial number of the signal transmitted by my garage door opener (which matches the frame structure presented in the datasheet). However, I just have 28 bits (0's and 1's) and I don't know how I could verify that that's correct as I don't see that number in decimal or hexadecimal written anywhere.
Is that something the fob's manufacturer programmed? Do you know how I could verify/translate those 28 bits?
The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.
Reading HCS301 serial number, how to verify
1 post
• Page 1 of 1
Reading HCS301 serial number, how to verify
by natiya » Sat Sep 08, 2018 7:52 am
- natiya
- Posts: 2
- Joined: Sat Sep 08, 2018 7:47 am
1 post
• Page 1 of 1
Return to Microcontrollers & Embedded
Who is online
Users browsing this forum: No registered users and 2 guests