The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Thermocouple for oven controller

The electronics enthusiast's product design cycle
Post a reply

Postby johnrr » Wed Mar 18, 2009 12:00 am

I have just ordered an Elektor reflow oven controller. Is the thermocouple included with the kit?

If not, what type is it? The parts list for the earlier version specified a Type K thermocouple. Is this still the same?

Digikey (in North America) sell a K type thermocouple which has a bare exposed junction. Is this OK assuming that care is taken not to short it to anything.

Thanks for any help

John.
johnrr
 
Posts: 1
Joined: Thu Jan 02, 2014 10:39 am
Top
Post a reply

Return to CAD, Simulation, PCBs, Making, 3D Printing

Who is online

Users browsing this forum: No registered users and 2 guests

Powered by phpBB® Forum Software © phpBB Group