In the course on page 46 in figure 37 I don't find in port C , RC3.
I understand that because in flowcode it is als not possible to program Bit3 of port C
But in that figure I don't find RD1. Why is that so? Yet in flowcode it is possible to program that bit.
The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.
RD1?
2 posts
• Page 1 of 1
by geenbert » Sun Sep 09, 2012 12:00 am
In the course on page 46 in figure 37 I don't find in port C , RC3. I understand that because in flowcode it is als not possible to program Bit3 of port C
Correct. RC3 does not exist, hence you cannot program it.
But in that figure I don't find RD1. Why is that so? Yet in flowcode it is possible to program that bit.
It's somewhat hidden. The first line says "RD0/SPP0:RD4/SPP4". The colon means "up to", so "RD0/SPP0 up to RD4/SPP4". So it also includes RD1/SPP1, RD2/SPP2 and RD3/SPP3.
- geenbert
- Posts: 83
- Joined: Thu Jan 02, 2014 10:41 am
2 posts
• Page 1 of 1
Return to Programming Embedded PIC Microcontrollers using Assembly, C and Flowcode
Who is online
Users browsing this forum: No registered users and 1 guest