The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

It is great to make an Elektor project or ?....

OBD, CAN, EV, RV
Post a reply

Postby oz1cd » Wed May 30, 2007 12:00 am

Hi

I wrote a while ago about a problem i had with the EOBD project and my Mazda and no responce I had hoped that there would be some backup but I was wrong or maybe a bit disappointed.

Christian..
oz1cd
 
Posts: 6
Joined: Thu Jan 02, 2014 10:38 am
Top

Postby bulent » Wed May 30, 2007 12:00 am

Hello

Please check the PCA82c251 and line terminators 2x100 ohm and 470/560 pF

best regards
Bülent
bulent
 
Posts: 16
Joined: Thu Jan 02, 2014 10:38 am
Top

Postby oz1cd » Wed May 30, 2007 12:00 am

I checked all that and it works but if I put in the EOBD in the OBDII connector in my car with out the PC connected it makes an error in the DTC which must be a bug in the 2600 cpu software.
Christian..
oz1cd
 
Posts: 6
Joined: Thu Jan 02, 2014 10:38 am
Top
Post a reply

Return to Automotive Electronics

Who is online

Users browsing this forum: No registered users and 1 guest

Powered by phpBB® Forum Software © phpBB Group