Hi,
I'm building the diseqc monitor. I see that in the circuit diagram C5 is 2n2 and the same C in the components list is 220pF. What is correct ?
regards
Marc ON4MDB
Belgium
The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.
DISEQC MONITOR
2 posts
• Page 1 of 1
by Guest » Wed May 30, 2007 12:00 am
hi Marc,
the value of C5 was originally 2.2nF according to the Eutelssat specs and worked okay with Nokia sets. Later it was discovered that 2.2nF was required for Dreambox sets -- this value also worked with the Nokia 9500 set. Give it a try!
We're sorry this additional information arrived too late for inclusion in the article.
EE Labs
the value of C5 was originally 2.2nF according to the Eutelssat specs and worked okay with Nokia sets. Later it was discovered that 2.2nF was required for Dreambox sets -- this value also worked with the Nokia 9500 set. Give it a try!
We're sorry this additional information arrived too late for inclusion in the article.
EE Labs
- Guest
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest
