The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Using an atmega328 with a quartz

The topic on number crunching
Post a reply

Using an atmega328 with a quartz

Postby Nixies » Tue Feb 10, 2015 8:58 pm

Hello, I'am using an atmega 328 and I would like to run it with a 16 MHz cristal. Could you explain me how I can do it atmel studio 6.2 ?
I have already tried but I broke my µc :-(
Thank you very much.
Nixies
 
Posts: 11
Joined: Fri Jan 30, 2015 9:04 pm
Top

Re: Using an atmega328 with a quartz

Postby ag » Wed Feb 11, 2015 6:44 pm

Hi Nixies,

Check out this link (then scroll to "Setting up Clock Frequency F_CPU"):

http://maxembedded.com/2012/06/using-atmel-studio-6/

and in particular, this link, also found there:

http://www.ladyada.net/learn/avr/fuses.html

Regards,
Ag
ag
 
Posts: 533
Joined: Thu Jan 02, 2014 10:37 am
Top

Re: Using an atmega328 with a quartz

Postby Nixies » Wed Feb 11, 2015 10:47 pm

Hi ag,

I have tried the Embedded link without success. The site does not reply. I will try again later.
The second link is very interresting and I will look closely at it.

Thank you very much.
Nixies
 
Posts: 11
Joined: Fri Jan 30, 2015 9:04 pm
Top

Re: Using an atmega328 with a quartz

Postby Gohinne63 » Mon Apr 13, 2015 2:36 am

Thanks for these informations. :D
Gohinne63
 
Posts: 1
Joined: Mon Apr 13, 2015 2:19 am
Top
Post a reply

Return to Microcontrollers & Embedded

Who is online

Users browsing this forum: No registered users and 2 guests

Powered by phpBB® Forum Software © phpBB Group
cron