The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Non-resist coated pcb laminate required

The electronics enthusiast's product design cycle
Post a reply

Postby pewtu » Sun May 12, 2013 12:00 am

I have a particular requirement for some non-resist coated pcb laminate. Ideally this would be 0.8mm instead of the usual 1.6mm but this is not the prime requirement. I want 1/2oz copper, not 1 oz. I have looked at RS, Farnell, Rapid and Mega. Anyone any ideas?
pewtu
 
Posts: 5
Joined: Thu Jan 02, 2014 10:39 am
Top

Postby pcbworker.com » Wed Jul 24, 2013 12:00 am

hi, could you send me the specific document to this email address：sales@pcbworker.com?
pcbworker.com
 
Posts: 1
Joined: Thu Jan 02, 2014 10:40 am
Top
Post a reply

Return to CAD, Simulation, PCBs, Making, 3D Printing

Who is online

Users browsing this forum: No registered users and 1 guest

Powered by phpBB® Forum Software © phpBB Group