I have the gerber files that came with the 20/40 Mhz Logic Analyzer in 2/2003. These files were created by Elektor with ultiboard and have the RS-274D format.
I would like to get the gerber files in the RS-274X format from the old RS-274D files that were created.
Does anybody know of any software that can do this and that can handle the old ultiboard aperture file format?
The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.
How transfer elektor gerber from RS-274D to RS-274X
2 posts
• Page 1 of 1
How transfer elektor gerber from RS-274D to RS-274X
by Tailgunner » Wed Nov 21, 2018 3:47 pm
- Tailgunner
- Posts: 5
- Joined: Wed Nov 21, 2018 3:40 pm
Re: How transfer elektor gerber from RS-274D to RS-274X
by vedika31 » Mon Feb 18, 2019 4:12 am
You may need to edit the gerber files in Sprint Lay out, this I think is the easiest way. I also use Sprint Lay out and when I see errors in fhe Gerbviewer I re-open fhe files in Sprint to correct the errors. Software compatibility is always an issue when working with files like this.
Hope it helps!
Hope it helps!
- vedika31
- Posts: 4
- Joined: Sat Feb 16, 2019 7:15 am
2 posts
• Page 1 of 1
Return to CAD, Simulation, PCBs, Making, 3D Printing
Who is online
Users browsing this forum: No registered users and 2 guests