The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

E-Wheelie: What about the vref on the sensorboard?

OBD, CAN, EV, RV
Post a reply

Postby pi » Sun Jul 18, 2010 12:00 am

In figure 2 is shown that vref (1,23V) is connected on the K1 connector. This in turn connected to the K2 connector of the mainboard. But looking at figure 3 there is no connection. So it floats or is not used.
pi
 
Posts: 2
Joined: Thu Jan 02, 2014 10:38 am
Top
Post a reply

Return to Automotive Electronics

Who is online

Users browsing this forum: No registered users and 1 guest

Powered by phpBB® Forum Software © phpBB Group