FT232R Drivers for RFID Reader 060132-91

[jclark]

I am trying to get my Elektor RFID reader 060132-91 working with my new HP Envy 4 Win7 laptop. The first problem I have is getting a driver for the FT232R USB interface. Using the Microsoft USB reader, I see that the Vid & Pid are different from the ones supported by FTDI. How can I get this going?


bMaxPacketSize0: 0x08 (8)
idVendor: 0x0C7D
idProduct: 0x0005
bcdDevice: 0x0600
iManufacturer: 0x01
0x0409: "FTDI"
iProduct: 0x02
0x0409: "FT232R USB UART"
0x0409: "FT232R USB UART"
iSerialNumber: 0x00
bNumConfigurations: 0x01
ConnectionStatus: DeviceConnected
Current Config Value: 0x00
Device Bus Speed: Full
Device Address: 0x01
Open Pipes: 0
Configuration Descriptor:
wTotalLength: 0x0020
bNumInterfaces: 0x01
bConfigurationValue: 0x01
iConfiguration: 0x00
bmAttributes: 0xA0 (Bus Powered Remote Wakeup)
MaxPower: 0xC8 (400 Ma)
Interface Descriptor:
bInterfaceNumber: 0x00
bAlternateSetting: 0x00
bNumEndpoints: 0x02
bInterfaceClass: 0xFF
bInterfaceSubClass: 0xFF
bInterfaceProtocol: 0xFF
iInterface: 0x02
0x0409: "FT232R USB UART"
0x0409: "FT232R USB UART"
Endpoint Descriptor:
bEndpointAddress: 0x81 IN
Transfer Type: Bulk
wMaxPacketSize: 0x0040 (64)
bInterval: 0x00
Endpoint Descriptor:
bEndpointAddress: 0x02 OUT
Transfer Type: Bulk
wMaxPacketSize: 0x0040 (64)
bInterval: 0x00

[ag]

Hi jclark,

I believe you need to update both the controller program as well as the smartcard communications program. Sorry that it is in German, but try this site for more information and downloads for the required updates:

http://www.smartcard-magic.net/elektor-rfid-reader/

Regards,
Ag

[jclark]

Many thanks I will check out the site.
J.Clark/Toronto