The Elektor Forum will close. See also
this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.
The electronics enthusiast's product design cycle
by Opreican » Fri Dec 08, 2017 10:53 am
JohnF wrote:I have a PCBbox that I need to adjust the hole positions are out, but to do that I need access to the settings dialgue in PCBmodule has anyone the password for access to this?
I also have an elektor profiler that I require Colicam and colidrive for can anyone help with this?
I kind of had it, what you need.
I'll look for the password in my last project. If I find it. Send it
All that we see or seem is but a dream within a dream.-
Edgar Allan PoeNew
hobby..Start from 2018.
-
Opreican
-
- Posts: 1
- Joined: Fri Dec 08, 2017 10:34 am
by JohnF » Wed Dec 13, 2017 5:49 am
I have been using my PCB box with an error in hole positions, when doing double sided boards. but now I am working with a mix of SMD and through hole components the holes errors are causing a problem on the second side of the board. I would apreciate getting the password for the settings dialogue ib the PCBmodule, so I can adjust this error.
-
JohnF
-
- Posts: 3
- Joined: Sun Dec 03, 2017 12:39 pm
Return to CAD, Simulation, PCBs, Making, 3D Printing
Who is online
Users browsing this forum: No registered users and 1 guest
