The Elektor Forum will close. See also
this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.
Equipment, circuits, projects, procedures
by Goldwayfrench » Sat Dec 22, 2018 4:02 pm
[list=]k[/list]
Hi everybody
This is m'y forts post on this forum
I am currently working to design a new tube valve tester
( without PC remonte )
M'y idéal is to sélect all thé modules on eBay at verty low cost and
Do intégration of thé selected modules
I sonder if dôme of you are interrested to folow m'y buiild
Best regards
-
Goldwayfrench
-
- Posts: 2
- Joined: Sat Dec 22, 2018 3:15 pm
- Location: Française
Return to Test & Measurement
Who is online
Users browsing this forum: No registered users and 1 guest