The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Mifare Access Control Configuratiuon

The topic on number crunching
Post a reply

Postby marcoc62 » Wed May 30, 2007 12:00 am

Regarding Mifare Magic Version 2.0
i would like to use the Access Control Feature
but it seems it doesn't work at all
what i have to do ?
where i can find instructions ?
Have the jumpers to be fitted ?

marcoc62
 
Posts: 3
Joined: Thu Jan 02, 2014 10:42 am
Top

Postby bodgy » Wed May 30, 2007 12:00 am

I have never been able to get this to work either. I just get an error message about incorrect frame.

I tried to convert the software to Visual Studio, but wasn't successful on the first attempt and haven't bothered since. One day........


Colin
bodgy
 
Posts: 3
Joined: Thu Jan 02, 2014 10:42 am
Top

Postby marcoc62 » Wed May 30, 2007 12:00 am

All the problems disapear putting on the right LCD or a 1Kohm resistor between pin 14 D7 and gnd if you have no LCD
marcoc62
 
Posts: 3
Joined: Thu Jan 02, 2014 10:42 am
Top
Post a reply

Return to Microcontrollers & Embedded

Who is online

Users browsing this forum: No registered users and 2 guests

Powered by phpBB® Forum Software © phpBB Group
cron