The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Download firmware

OBD, CAN, EV, RV
Post a reply

Postby antonvn » Wed May 30, 2007 12:00 am

Judging by the replies to the JP1 questions, it seems that it may be possible to program the chip in place.

If this is the case, could you please provide the instructions on how to program the chip without removing it from the circuit? My programmer does not have a socked for the T89C51CC02UA type chips and if the chip can be re-programmed in line/place, it will be very useful when you release updates.
antonvn
 
Posts: 1
Joined: Thu Jan 02, 2014 10:38 am
Top

Postby Elektor Editor » Wed May 30, 2007 12:00 am

The author Mr. Ozen should know. He is on this forum occasionally.

regards,
Jan
Elektor Editor
 
Posts: 467
Joined: Thu Jan 02, 2014 10:36 am
Top

Postby bluetooth1 » Wed May 30, 2007 12:00 am

Short J1 pins together, apply power then run Atmel FLIP program. Load your HEX file via the serial port. Comms at 57600 8N1.
bluetooth1
 
Posts: 2
Joined: Thu Jan 02, 2014 10:38 am
Top
Post a reply

Return to Automotive Electronics

Who is online

Users browsing this forum: No registered users and 1 guest

Powered by phpBB® Forum Software © phpBB Group