The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

more novel pcb making

The electronics enthusiast's product design cycle
Post a reply

Postby vvvv » Sat Sep 13, 2008 12:00 am

It's happened again.I ran out of tranparencies for my ink jet printer to print artwork for a pcb.
Printed on normal paper, sprayed liberally with WD40 and left out to dry for a couple of hours to transparasize it.
Then doubled the normal exposure time.Worked a treat!

Regards
RG
vvvv
 
Posts: 48
Joined: Thu Jan 02, 2014 10:36 am
Top

Postby sarma » Sat Sep 13, 2008 12:00 am

You can also use Tracing paper ( the one used for making machine and civil drawings before computer software took over. for UV transparency.)
sarma
 
Posts: 155
Joined: Thu Jan 02, 2014 10:36 am
Top
Post a reply

Return to CAD, Simulation, PCBs, Making, 3D Printing

Who is online

Users browsing this forum: No registered users and 2 guests

Powered by phpBB® Forum Software © phpBB Group